Open 24 hours, 7 days a week
Repiping for Hollywood’s older supply lines
Aging galvanized or corroded copper supply lines are replaced with new piping run through the same general paths, restoring pressure and water quality without redesigning the house.
How do I know if my house needs to be repiped?
Low water pressure across the whole house, water that runs rusty or discolored right after the tap is turned on, and frequent small leaks at different fittings are the usual signs that the supply piping itself is corroding from the inside rather than one fixture being at fault. Galvanized steel supply lines, common in homes built through the 1960s, corrode from the inside and narrow gradually until they choke off flow.
A single pinhole leak in an otherwise sound copper system is often a local repair, not a reason to repipe the whole house. It is the pattern that matters: several leaks over a short span, or pressure that has been dropping for years, points at the piping itself rather than any one spot in it, and that pattern is worth mentioning when you call.
Signs the lines are failing
What points at the supply lines, not one fixture
Low pressure at every fixture, not just one
A house-wide drop usually means the supply lines themselves, not a single valve.
Rusty or discolored water right when a tap opens
Corrosion inside galvanized pipe releasing into the first water through.
Multiple small leaks in different spots over time
Pinhole leaks appearing in more than one place points at the pipe material aging out generally.
Visible corrosion where pipe is exposed
Rust or scaling on any section of supply line you can actually see.
How the work is done
Repiping without redesigning the house
New piping generally follows the same routes the old lines already take through walls, ceilings or under the slab, which keeps the work to opening and patching access points rather than reworking the whole structure. Copper or PEX are the two common choices today, and which one fits depends on the house, the budget and how the existing lines are routed.
Access points are patched once the new lines are pressure-tested and confirmed sound, and the work is inspected and permitted the way any plumbing system change is under Florida code.
What the work looks like
Whether the house has to be vacated during a repipe
Most repiping is staged room by room or floor by floor, so water is only off in the section being worked on at any given time rather than the whole house at once. Walls are opened where the old pipe runs and patched afterward, which is drywall work rather than structural work.
Whether a repipe makes more sense than patching one failure at a time usually comes down to the pipe material and its age. A house with recurring pinhole leaks in copper, or with polybutylene or galvanized supply lines, is often past the point where another single-spot repair is the better value.
Questions
Repiping, answered
Do you have to open up every wall in the house?
Access points are opened where the new lines need to run, not the entire wall. Most are patched and ready for paint once the work is done.
How long does a whole-home repipe take?
It varies with the size of the house and how the lines are routed. A plumber can give you a realistic timeline after seeing the layout.
Is PEX or copper the better choice?
Both are used successfully. Copper has a long track record; PEX is more flexible to route and resists the corrosion that affects older galvanized pipe. A plumber can walk through which fits your house.
Can I stay in the house during a repipe?
In most cases, yes, though water will be off in sections while that portion of the work is in progress.
Live dispatch
Pressure dropping across the whole house?
Call and describe what you are seeing. A plumber can tell you whether it is one fixture or the supply lines themselves.
No obligation to book after the call.